Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
3.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL
74646A
4.REMOVE DOOR ASSIST GRIP COVER LH
69284D
5.REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH
67604
6.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
67842E
7.REMOVE REAR DOOR SERVICE HOLE COVER LH
68152C
8.REMOVE REAR DOOR GLASS RUN LH
67408E
9.REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH
68124B
10.REMOVE REAR DOOR QUARTER WINDOW GLASS LH
68104
11.REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH
75740
12.REMOVE REAR DOOR BELT MOULDING ASSEMBLY LH
| *1 | Protective Tpae |
Put protective tape around the rear door belt moulding.
Detach the 8 claws and remove the rear door belt moulding.